Select your product to confirm this information applies to you
On-screen Error Messages on a LiveScope™ Scanning Sonar
If a component of the LiveScope™ scanning sonar system disconnects during use, the connected chartplotter will display an error message, and the GLS™ 10 sonar module will display an LED pattern. After acknowledging the error message, the message and LED light pattern may change. See the table below to determine which error message corresponds with which disconnected component.
Disconnected component | Error message | GLS 10 LED behavior |
Power cable | A Panoptix Transducer is Disconnected After acknowledgment: Sonar Service Off | No light |
Garmin Marine Network cable | A Panoptix Transducer is Disconnected | LED flashes red continuously |
Transducer cable | A Transducer is disconnected. The sonar has been turned off. | LED flashes red three times |
Reconnect the indicated component to resolve the error message. See Troubleshooting Marine Sonar Modules if the message recurs.