Select your product to confirm this information applies to you

How to Reset the Rino 750 or 755t

There are a few instances in which it is necessary to perform a full reset on a Rino® 750 or Rino® 755t outdoor radio, including the following:

  • Not receiving a satellite signal
  • Restoring the factory default settings
  • Not functioning properly

The information and steps below will walk you through backing up your data and resetting.


Before Resetting

Performing a full reset can cause user data loss. User data is waypoints, routes, tracks, activities, contacts and geocaches.

It is recommended to back up important data with BaseCamp™ software before resetting. For steps, see Related.

Note: Contacts cannot be backed up and will be erased during a reset. Contacts can be re-added by accepting the prompt to save the contact once the other device has initiated a transmission.

If removing data is desired to eliminate corrupt data or free up space, see Related.


Performing a Full Reset

  1. Power the Rino off
  2. Press and hold Call Call Rino  (found on top left of the device)
  3. Power the device on while still holding down the Call button
  4. Release the Call button when you see the Erase all user data? message
  5. Touch Erase

The Rino has now been reset. You will want to take the device outside in a clear view of the sky for a minimum of 20 minutes to re-acquire satellite data.


Reset with Device Stuck at Garmin Logo

  1. Power the Rino off
  2. Press and Hold: Call, Volume Up & Volume Down Buttons
  3. While holding the button combo: Press the Power Button
  4. Release all the buttons when the Garmin logo appears

The Rino should produce a beep and load the Main Menu


Related