Select your product to confirm this information applies to you

Je bekijkt een artikel dat niet beschikbaar is in de geselecteerde taal. Je kunt hieronder een andere taal kiezen.

Replacement Locking Collars for Garmin® Marine Devices

Newer Garmin® cables do not have the locking collars factory-installed; this allows for easier installation when routing the cables through and behind cabinetry. The two-piece locking collar is attached to the connector. Double-check, the box for the included split locking collar but if lost or if a replacement is needed, see the below list for part numbers. Refer to  Marine Cable Locking Collar / Split Connector Installation for instructions.


11mm Cables
    • Threaded Locking Collar - 010-11170-01

      • 2-pin power cable GPSMAP® 4xxx and GPSMAP® 5xxx series (verify threaded)

      • 8-pin power cable (some ECHOMAP™s and GPSMAP®)

      • Power cable - GSD™ 24, GSD™ 25, and GSD™ 26, GCV™ 10, GCV™ 20  

      • 8-pin transducer cable

      • 12-pin transducer cable 

      • Small Marine Network cable

      • Power cable - AIS 300 and 600 

      • GHC™ 101 , GHC™ 20, and GHC™ 50 

      • GHP™ 10 ECU connections2

      • GHP™ 12 ECU connections

      • All Garmin Marine Radar systems1

1 check for threaded or quarter turn port. Depending on the manufacture date, all Garmin radars could contain a threaded or a quarter-turn connector. Confirm which collar is needed before placing an order

2 This only applies to GHP 10 ECUs packaged in the Reactor 40 Core packs


14.5mm Cables
    • Threaded Locking Collar - 010-11170-02

      • 19-pin power cable GPSMAP® 7x0 series

      • NMEA 0183 cable  GPSMAP 4xxx 5xxx, 6xxx, 7xxx, and 8xxx (verify thread on the GPSMAP 4xxx - 5xxx series) 

18mm Cables
    • Threaded Locking Collar - 010-11170-00

      • Large Network Cables (RJ 45) - including Panoptix series transducers and sonar modules

      • LVS32 LiveScope Transducer

      • Video cable GPSMAP 4xxx, 5xxx, 6xxx, GPSMAP 7xxx  (verify thread on the GPSMAP 4xxx-5xxx series)