Select your product to confirm this information applies to you
GHP Autopilot Set North Procedure
The Set North procedure will need to be performed to run the GHP Autopilot in GPS mode. The Set North procedure will properly align the Course Computer Unit (CCU) known as the Reactor to the magnetic north. Without performing the Set North procedure, the GHP will not be able to follow a GPS route. Directions are below on how to put into Dealer Mode to access the Set North setup.
Dealer Mode
Select Menu
Select Setup
Select System
Select System Information
Press and hold the center soft key until Dealer Mode displays
Press the back button twice
Set North
When performing the set North Procedure, there must be a large stretch of open water available and calm surface conditions are best for setting North. Begin driving the vessel in a straight line at cruising speed, downwind and in the same direction as the current.
Select Dealer Autopilot Setup
Select Compass Setup
Select Set North
Select Begin
Continue to drive the boat in a straight line at cruising speed, downwind in the same direction as the current, and follow the on-screen instructions
For more information on the Set North procedure, refer to the Configuration Manual of the autopilot.